Professional 8-Way Active Type CATV RF Splitter With DC Power Pass
Premium 8-Way CATV RF Active Splitter With DC Power
Pass
This CATV RF splitter is a premium active type 1Ghz RF signal splitter for private cable
TV, antenna, analog/digital broadcast TV or MATV employing multiple modulators and other RF coax equipment.
It can distribute TV signal to 8 locations or 8 TVs.
Each RF splitted
output will retain the same level with no loss.
It is an active type RF signal splitter with DC
12V power supply, Ideal for CATV, surveillance CCTV, antenna TV coaxial operations.
True Lossless 8-Port Splitter
This splitter can provide 8 amplified output ports
with zero loss through the internal gain amp.
Active Type RF Splitter
A passive non-powered type cable TV splitter will degrade the original RF signal
even if the other output ports are not used.
This active type splitter includes a DC 12V power
adapter for its internal amplifier so each one of the 8 RF outputs carries will
retain the same signal level as
the original RF input.
Wide Frequency Range Support
This unit supports a broad frequency range from 45 to 1000MHz. Most of the
RF TV signals such as cable TV or antenna TV signals can be handled by this
unit.
DC
Power Pass
The 1st RF output port of this
splitter supports
DC power
pass function so it can pass the DC power voltages/currents
to power a RF device connected over the coax cable.
High Isolation
This CATV combiner provides high Port-To-Port isolation between RF TV
signals so each output can be transmitted in
stable quality with no noise or interference incurred.
|
- Professional high-end 1 in 8 out digital/analog RF
cable TV signal splitter and distribution amp.
- Designed to divide/duplicate single RF input into
8 identical RF outputs with zero loss.
- Distribute TV signal to 8 locations or 8 TVs
and each RF splitted
output will retain the same level with no loss.
- Ideal for CATV, surveillance CCTV, aerial
TV and MATV coaxial operations.
- Supports broadband frequency range of 45 to
1000MHz.
- The 1st RF output port of this
splitter supports
DC power
pass function so it can pass the
DC power voltages/currents to drive a RF device connected over the coax cable.
- Low-noise filter with high port-to-port
Isolation.
- 75-ohm impedance for all outputs provides the best possible signal.
- RFI shielding for minimized egress/ingress interference.
- Die cast housing for absolute minimal
losses.
- Grounding terminal available
-
RF Input: 75 ohm, Coax F-Type Female x 1
-
RF Outputs: 75 ohm, Coax F-Type Female x 8
- DC Power Pass: VDC, one port only
- Frequency Range: 45~1000MHz
- Input Power: 75 dBuV
- Insertion Loss: typical 1dB
- Frequency Response: typical 2 dB
- Isolation out-to-out: typical 20 dB
- Return Loss-Input: 12~14dB, typical
13 dB
- Return Loss-Output: 10~12dB, typical
11 dB
- Noise Figure: typical 5 dB
- Power Supply: AC input 100-240V with
DC output 12V / 1A